For this week I have fully finished my fuzzy system data which will be use for my Labview simulation block diagram. Thus I have continue to design the block diagram and front panel of Labview.
Labview front panel for prototype 1 is as below:-
The heater and fan meter show the amount of power,% of the motor used. While arrow of slide properties are to be set by user to see whether the simulation can produce output as expected or not. While Numeric indicator are to shown exact value that the temperature are reading.
But problem occurs at block diagram level which shown as below:-
From picture above we can see MIMO or Multiple Input Multiple Output for fuzzy system design block cannot connect to two output at the same line. The results are failure of output production.
While in use of MISO or Multiple Input Single Output option, only the heater meter are producing output. But Fan consist of no output reading of its own, only the same as Heater reading as shown below.
Thus I need to consult with my adviser regarding the problem.
No comments:
Post a Comment